The Android community nowadays is at odds about the best rooting tool but regarding convenience, most agree that KingoRoot is one of the leading names. Featuring a combination of straightforward setup process and user-friendly interface, KingoRoot allows Android users to root their phones in a blink of an eye. However, like any other rooting tool, KingoRoot may create several issues for devices and reboot loop is a prime example. When KingoRoot keeps rebooting, people would be unable to use their phones until they address the root of the situation.
Your phone also gets stuck in an indefinite reboot loop after being rooted with KingoRoot? Then it’s strongly recommended that you spare some time to check out this article. By reading the following information, you could find out what needs to be done to fix the KingoRoot reboot loop.
Putting An End To The Reboot Loop: Suggestions
Different troubles often require different solutions but regarding the reboot loop of KingoRoot, it’s a good idea to try out the measures down below
Remove And Reinsert The Battery
The “turn it off and on again” trick is effective at getting rid of an assortment of errors on Android. Still, if your phone constantly reboots after rooting, you need to resort to a forceful alternative: get the battery out and put it back in. Needless to say, it’s important to be attentive here to minimize the odds of the phone battery sustaining damages. Assuming that things proceed smoothly, your Android phone is going to boot like usual again.
Proceed To Remove All Knox
If your phone is a Samsung model, there is a chance that it features Knox. Designed from the ground up as a security layer, Knox should protect your data from a wide range of exploits. That being said, while it meant well, Knox could impair the operation of rooted devices. Therefore, when KingoRoot keeps rebooting as you finish rooting your phone with it, it’s essential that you remove all Knot as fast as possible.
Perform A Factory Reset
Following a factory reset, your Android device is going to return to its original configuration so all problems automatically go away. Naturally, once it comes to persisting troubles on Android that don’t resolve no matter what, a factory reset is the number one fix. Keep in mind that if you perform a factory reset, nothing would remain in the internal memory in the end. That is why you have to back up key data of your phone in advance.
Flash The Firmware
So you cannot access the system settings of your phone and have a hard time performing a factory reset? In that case, you need to think about flashing the firmware.
To flash the firmware of an Android phone, you have to obtain the firmware first. Nowadays, you could get your hands on firmware of various devices that run on Android by rummaging around the Internet. Next, ensure that you have the firmware and a compatible flashing tool on your computer. Finally, get your phone into Download Mode (holding Home, Volume Down and Power buttons simultaneously), connect it to your computer and begin flashing the firmware.
Advice For Rooting Android Phones
KingoRoot keeps rebooting is one of a lot of issues that Android users may come across while rooting their phones. Nonetheless, if you consider these guidelines, you should be able to avoid plenty of headaches
- Know the gains and risks: Rooting indeed permits you to take control of various aspects of your device but it introduces new vulnerabilities as well. Because of that, you have to think it rough prior to rooting your Android phone.
- Choose the rooting tool wisely: The success of rooting depends largely on the rooting tool and that means you have to make a wise choice. certain modern tools happen to be tailored for particular builds of the Android operating system. Using the wrong rooting tool for the wrong build of Android might brick the phone.
- Voided warranties: Warranties that accompany your device would be voided the moment you root it. Thus, you have nothing to count on when problems occur and you must deal with repair bills on your own.
I am a Software developer with approx 4 years of experience in building various responsive and beautiful websites and apps.
Language: Ruby, Java, HTML/CSS, Android
Frameworks: Ruby on Rails, Hosting: Heroku, Godaddy
Database: Mysql, Postgres, Mongo, Oracle
Also please look on my stack overflow profile.